Truma Therme TT2 replacement tank kit, comes with 3 O rings and 2 drain valves. This is a new tank and tank jacket, all other parts need to be removed from your existing unit. For a complete new unit see part no. CCG 2137 in Appliances section.
CCG 27061 Henry Wiring Harness Wiring harness for Henry water heater. This harness is only required if
you are fitting a replacement Burner Module Part No. CCG 2706 and you
have the older model of Cascade 2 water heater that has the round
multi-pin plugs fitted. It is not required if you are purchasing a
complete Heater Part No. CCG 2138 as this harness is included.
CCG 27071 Truma Adapter Plate Truma adapter plate which allows you to replace a Carver Cascade 2 water heater with a Truma Ultrastore water heater, without the need to modify the bodywork of caravan / motorhome.
Thermal saftey cut out switches for Henry heater electric element, these are supplied as a pair, one is a overload reset switch and one is an over temperture switch. Note fixing screws not supplied.
CCG 2713 Carver Drain Plug Imperial Carver Cascade 2 water heater drain plug fits early models, this is an alternative fitting that replaces the old obsolete plastic bung which is identified by the cross on top, this a nickel plated brass fitting with imperial thread and complete with 'O' ring, requires an allen key type tool for fitment. Generally used on pre 1987 models.
Truma Ultrastore heating element, 230 V / 850 W used from 07/03. Can be used as an upgrade replacement for the 450W element above. This is the same element used in the new Truma Electric EL water boiler.
When retro fitting for a 450w ensure the tank has 2 fixing studs to attach the over heat sensor.